• 1144953 3 2x
  • 1144953 3 2x

- Accuracy as per IS-4960-1968

- Grade-A Hardened & Ground

- Grade-B Extra dense cast iron

<

'V’ Blocks are required for Quality Control, Tool Room and Standard Room. "Crystal" Brand Magnetic 'V’ Blocks have high magnetic pull, hence they can be used fro drilling and grinding (both wet and dry) and even for light milling work.

The 'V’ Block has a total three magnetic surfaces. Top and Bottom with 90 'V’ angle and end surface opposite to switch. All three magnetic surfaces and the two sides are carefully ground. Their accuracy for flatness, parallelism and squareness is within 0.005 mm for 2", 3", 4" & 6" 'V’ Blocks. When turned "ON" all three magnetic surfaces are activated Simultaneously.

The permanent magnet holds the work firmly in the 'V’ and if the block rests on a magnetically conductive surface, it is held firmly to this surface. The magnetic pull is constant and will not decrease eveb after long use. The magnetic system being shielded from penetration of moisture, cannot be damaged by coolants or other fluids.

CAT NO. W X L X H
AA - 1771 50 x 40 x 40 mm
AA - 1772 50 x 50 x 50 mm
AA - 1773 63 x 50 x 50 mm
AA - 1774 63 x 80 x 80 mm
AA - 1775 63 x 100 x 100 mm
AA - 1776 70 x 140 x 140 mm
AA - 1777 80 x 63 x 63 mm
AA - 1778 100 x 80 x 80 mm
AA - 1779A 150 x 200 x 200 mm
AA - 1779B 200 x 200 x 200 mm
AA - 1779C 300 x 300 x 300 mm
CAT NO. W X L X H
AA - 1781 100 x 63 x 100 mm
AA - 1782 160 x 80 x 100 mm
AA - 1783 200 x 100 x 200 mm
AA - 1784 300 x 125 x 300 mm
AA - 1785 120 x 60 x 120 mm
AA - 1786 150 x 175 x 150 mm
AA - 1787 190 x 90 x 190 mm